Beisler 58 Instructions d'exploitation télécharger pdf (Page 47)

2-27

F2 Threat cutter

ATTENTION

The insertion station must be swung out and all threats and bobbins must be

removed from the sewing head before the test can be executed.

Press the 0-key (zero) and the sewing head runs for a short time. After the

needle has been positioned, the threat cutter gets active (basic parameter

36: TC duration).

F3 Position actor

ATTENTION

The insertion station must be swung out and all threats and bobbins must be

removed from the sewing head before the test can be executed.

After the selection of this test, the ‘Hand wheel increments’ and ‘Hand wheel

position’ will be displayed. By turning the hand wheel to the left or right, the

increments will be counted. There must be 520 increments per turn.

To check the needle-up-position, press the 0-key (zero) and the needle will

be positioned. There should be 510 increments displayed now. This value

should not deviate for more than 1 increment.

F4 Sewing motor

This function can be used to transfer the parameters required for the sewing

motor from the control. After changing the control or seam motor, the

execution of this function is required.

Select the function and press the ENT-key. The data will be transferred

automatically. Switch off the machine using the mains switch. After switching

on the machine again, the data will be loaded automatically.

5.5.2.3 Clamp motor

1. Press the P-key.

2. Press the F6-key.

3. Press the F3-key.

4. Press the F3-key.

Here three test functions for the clamp motor are contained:

F1 Clamp motor path steps

This function measures the path steps of the clamp path (see Technical

manual, 1.20.2).

F2 Select clamp motor

ATTENTION

This function may only be executed by service technicians of the company

Beisler or authorized and especially trained staff.

F3 Clamp motor long-term test

Hint

The main clamp must be driven into starting position (clamp on initiator 17)

before this function can be executed.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 77 78

Pas de commentaire

Beisler 58 Instructions d'exploitation Page 47