Beisler 58 Instructions d'exploitation télécharger pdf (Page 64)

3-14

2.5 Adjust piping width

To adjust the piping width, loosen both fixing screws (4)

at the clamp block. Tilt the clamp block with the help of

the setting screw (3) a very little to the left or right.

Tighten the fixing screws again.

Then you should check and possibly adjust the distance

to both clamps.

Hint

Double and signle piping width are adjusted in the

same procedure automatically.

Hint

After adjusting the folder, the positions of the marking

lamps must be checked and possibly adjusted.

Hint

The folder sole width is decisive for the piping width. It

can be changed if desired by the customer.

2.7 Lateral distance of the guiding plate

to the needle

Distance (A) to the needle should be minimized. The

guiding plate (1) may not get contact to the needle (2) or

needle head, since otherwise there would be loud noise

and the possibility of a threat break.

Adjust the distance using the corresponding bending tool.

2.6 Center knife protection

The center knife protection (2) is mounted at the folder.

It should surround the center knife (1) without touching

it.

Adjust the center knife protection (2) carefully if requi-

red.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 77 78

Pas de commentaire

Beisler 58 Instructions d'exploitation Page 64