Beisler 58 Instructions d'exploitation télécharger pdf (Page 65)

3-15

2.8 Height stop of the guiding plate

There may be a distance (A) of max. 0.5 mm between

upper side of the sole (2) and lower side of the guiding

plate (3). Only when sewing very thick material, distance

(A) must be enlarged.

To change the height, loosen the fixing screws of the

two screws (1) and turn them in or out. Tighten the fixing

screws then.

2.9 Pressure of the guiding plate

The spring pressure must be adjusted in a way that both

plates are pressed safely downwards at any time. If the

pressure is too low, a needle break can appear during

the front tack. If the pressure is too high, the flap will be

pushed back at seam start.

Turn both settings screws (4) until enough pressure is

present at the guiding plates.

2.10 Adjust marking lamps

2.10.1Adjust parallelity

The middle axis of the light crosses of the marking lamps

must be on the middle cut exactly.

Loosen the fixing screw (5) to adjust the marking lamp.

Loosen the fixing screw in the ring (4) to turn the mar-

king lamp.

2.10.2Adjust distance

The first line of the marking lamp seam start (1) must be

135 mm (A) away from the needle. The distance bet-

ween the first line of the marking lamp seam start (1)

and the last line of the marking lamp seam end (2) must

be 180 mm (B). The distance between the first line of

the marking lamp seam start (1) and the middle line of

the third marking lamp must be 90 mm (C).

Loosen the fixing screws (3) and push the marking lamps

until the correct distances are adjusted.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 77 78

Pas de commentaire

Beisler 58 Instructions d'exploitation Page 65