Beisler 58 Instructions d'exploitation télécharger pdf (Page 19)

1-17

4.2.4 Enable/disable seams

Seams are assigned to every sewing program. All enabled seams are sewed

sequentially. Enabled seams are displayed inverted (white on black).

If a seams shall be skipped, it must be disabled. How to enable/disable a

seam:

1. Move the cursor on the desired seam using the arrow keys.

2. Press the ENT-key to enable/disable the seam.

4.2.5 Change seam length

Several parameters of the current seam are imaged in the left half of the

display (e.g. seam length, mitre knife position). You can change these

settings individually using the function keys.

All changes executed with the function keys are stored for all seams with the

same number, even if they are used in different programs.

Further information are contained in the chapter ‘4.1.1.5 Function keys’.

4.2.6 Remove and add seams

You can add seams to and remove them from sewing programs:

4.2.6.1 Remove seams

1. Select the sewing program to be changed.

2. Press the P-key.

3. Press F1.

4. Move the cursor on the seam to be removed using the arrow keys.

5. Press the M-key.

6. Repeat steps 4. and 5. for all seams to be removed.

4.2.6.2 Add seams

1. Select the sewing program to be changed.

2. Press the P-key.

3. Press F1.

4. Use the arrow keys to move the cursor to the place, where you want to

add a seam.

5. Press the ENT-key.

6. Enter the number of the desired seam.

7. Repeat steps 4. to 6. for all seams to be added to the current sewing

program.

8. Press the P-key to store the settings and leave the submenu.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 77 78

Pas de commentaire

Beisler 58 Instructions d'exploitation Page 19